DIY Jewelry organizer

Being a merchandiser for Chloe and Isabel I am forever getting new pieces.  They wouldn’t fit in my jewelry box so I needed a creative solution.  So I made something. The finished product is at the bottom of this entry.

What you need to make this project:

  • A cork board.  I used a 2 foot by 3 foot one.
  • About 2 yards of whatever fabric you want to use
  • Cotton batting
  • ribbons of your choice (contrasting is what I used)
  • cup hooks (I used white cup hooks)
  • Craft Stapler I used Fiskars Craft Stapler
  • Fiskars Staples
  • Sewing Scissors 
  1.  cut a piece of cotton batting that would cover the cork board and and a little left over to be able to secure to the back.  Secure this batting with staples on the back of the cork board,
  2. Take your chosen material and steam or press so it is without wrinkles or creases.
  3. Spread the material on a large table.  Lay the cork board face down over the material.
  4. cut the excess material with enough to have a good margin to secure with staples.
  5. Secure fabric to the back of the board using staples.
  6. Measure about 3 inches from the top and place 5-6 cup hooks on this line.
  7. measure down 14 inches and mark with another line of 5-6 cup staggered from the cup hooks above.
  8. Repeat step 7 and place 5- cup hooks.
  9. Measure out your ribbon of choice  long enough to stretch across of the board and have a little left over on either side to secure on the back of the board as before.
  10. place ribbon strips a little above and a little below each row of cup hooks.  Secure to the back of the board
  11. hang the board using hooks and a picure hanging wire on your wall where you want it.
  12. hang your necklaces!

photo-nov-17-5-07-18-pm

Leave a Reply

Your email address will not be published. Required fields are marked *